Hitachi PSC-A32MN - Page 120

4 Individual remote controls
PC-ARF
TCGB0106 rev.0 - 12/2014
104
7 Press “ ” or “ ” and select “Check interval”.
Motion Sensor Setting
Sensor
ON
If absent
Running
Check interval
30MIN
ENT
.R
TN.SEL. ADJ
OK
OK
8 The display is switched “30MIN”, “60MIN”, “90MIN”, “120MIN”
and “180MIN” in order by pressing “
” or “ ” and change the
setting.
Motion Sensor Setting
Sensor
ON
If absent
Running
Check interval
30MIN
ENT
.R
TN.SEL. ADJ
OK
OK
9 Press “OK” after the setting is completed. The conrmation
screen is displayed then. Select “Yes” by pressing “
” or
“
” and press “OK”. The motion sensor setting is conrmed
and the screen returns to the normal mode (operation mode
indication).
A/C
LOUV.
Motion Sensor is activated
LOUV. ADJ
MODE SPEED
HEAT
MED
TEMP
Meeting Room
OK
Save changes?
Motion Sensor Setting
Yes No
SEL. ENT
.R
TN.
OK
OK
OK

Adjusting date/time
This function is used to adjust the date and time.
Periodic time setting is recommended. (Clock accuracy: difference within +/-70 seconds by month).
As for this remote control switch, the clock can work up to 72 hours when power failure occurs. Reset the date and time if
the remote control switch remains without power supply for longer than 72 hours or main power supply is OFF for long time.
1 Select “Adjusting Date/Time” from the menu and press “OK”.
Adjusting Date/Time
Fri
Function 13
RTN.SEL.
ENT.
OK
OK
2 Press “ ” or “ ” and select “yy/mm/dd/hh/mm”.
3 Press “
” or “ ” to change the setting. Press or keep pressing “ ” or “ ” to adjust numbers.