<Outdoor Unit Capacity Control>
5 Select the value for Outdoor Unit Capacity.
* The selected capacity value button is highlighted in yellow.
6 Use the buttons on the right side of the screen in order to schedule outdoor unit capacity control when there is no
external input contact being applied for this purpose.
* Select “Enable” or “Disable”.
* Tap “
” or “ ” to set the applicable starting time and ending time, in 30 minute steps.
* When the ending time falls earlier than the starting time, ending time becomes effective on the next day.
For example :
Starting Time 15:00
Ending Time 08:00,
Capacity control starts at 15:00 and ends at 08:00 on the following day.
7 Tap “Register”
(6)(5)
(7)
8 Select the target of capacity control (Refrigerant system).
* The buttons of the numbers of refrigerant systems of registered outdoor units are indicated in blue.
* The buttons of the numbers of refrigerant systems of unregistered outdoor units are indicated in grey. These refriger-
ant systems cannot be selected.
* Tap the button of a refrigerant system number in order to switch its selection state.
* Tap “Selec. all refr. syst” to switch the selection state of all refrigerant systems.
* The selected refrigerant systems are indicated with a check mark.
9 Tap “Setting completed” to conrm the setting contents and return to the External Input/Output Setting screen.
(9)(8)
5 Centralised remote controls
PSC-A32MN
TCGB0106 rev.0 - 12/2014
358
To Next Page
Loading...
