5.2.2.5 Run/Stop for Each Group
Check the control mode before setting.
The control method is different depending whether the control mode is set to “Normal” or “Run/Stop Only”.
Run/Stop operation for each group (Control mode: Normal)
1 Select the screen of “Monitor (All Groups)” or “Monitor (Block)”. Select the group to set by tapping its group button.
Monitor (All Groups) Monitor (Block)
(1) (1)
2 The settings of the selected group appear displayed on the touchscreen display. Tap “ON” or “OFF” to change the operation
state.
3 Tap “Monitor screen” to return to the “Monitor” screen.
(2)
(3)
Operation
PMML0332A rev.0 - 05/201532
To Next Page
Loading...
