Hitachi PSC-A32MN - Page 41


Run/Stop operation for each group (Control mode: Run/Stop only)
Monitor (All Groups)
1 Select the target group at the “Monitor (All Groups)” screen in “Run/Stop Only” mode.
2 The operation state of the selected group is switched alternatively between Run and Stop when tapping its button.
In this mode, simultaneous Run/Stop operation for all groups is available with the “Run all gr.” and “Stop all gr.” buttons.
Refer to section
³6FKHGXOHGVHWWLQJV´ for details.
(1)
(2)
Monitor (Block)
1 Select the target group at the “Monitor (Block)” screen in “Run/Stop Only” mode.
2 The operation state of the selected group is switched alternatively between Run and Stop when tapping its button.
In this mode, simultaneous Run/Stop operation by block is available with the “Run by Block” and “Stop by Block” buttons.
Refer to section
³6LPXOWDQHRXV5XQ6WRSIRUHDFK%ORFN´.
(1)
(2)
ENGLISH
Operation
PMML0332A rev.0 - 05/201533