~ 6 ~
DEHUMIDIFYING OPERATION
Use the device for dehumidifying when the room temperature is above 16°C.
When it is under 15°C, the dehumidifying function will not work.
Press the button so that the display indicates
“DRY” (DEHUMIDIFY).
The FAN SPEED is set at “LO” automatically.
Press the button.
■ When you want to change the operation mode, please use the
button.
■ Set the desired temperature is available.
■ You also can use the MODE selector to select this operation.
● Dehumidifying takes place with a target temperature which is slightly lower than the room temperature
setting. (However, target temperature is 16°C for a temperature setting of 16°C.)
If the room temperature becomes lower than the target value, operation stops. If the room temperature
becomes higher than the target value, operation restarts.
● When dehumidify operation restarts, even though the outdoor unit is running, the indoor unit may have no air flow
about 30 seconds. This is a reason to increase dehumidify effect, please wait a moment.
● The preset room temperature may not be reached depending on the number of people stay in the room or
other room conditions.
FAN OPERATION
You can use the device simply as an air circulator. Use this function to dry the interior of the indoor unit at the end of
summer.
Press the button so that the display indicates
“FAN”.
Press the button.
HI (HI) : The strongest air blow.
ME (MED) : Comfortable.
LO (LOW) : Quiet.
Press the button. Fan operation starts with a beep.
Press the button again to stop operation.
‧During the dehumidify operation, the function of TIMER will be useless, but the setting time can be
changed after pressing button.
‧During the timer setting operation, the function will be canceled after choosing “DRY” (DEHUMIDIFY ).
‧If want to run the dehumidify operation of TIMER, please use the button to set.
To Next Page
Loading...
