DEUTSCHFRANÇAIS
ITALIANOSPANISHPORTUGUÊS
∂ÏÏËÓÈοРУССКИЙ
Removing the Fresh Air In Pre-Filter
• Please pull out.
Removing the Nano-Titanium Disinfecting
Deodorizing/Dust Collecting Fresh Air In
Filter Case
• Please hold the
handle of the Nano-
Titanium Dis-
infecting Deodori-
zing/Dust Collecting
Fresh Air In Filter
Case and pull out.
Attaching the Nano-Titanium Disinfecting
Deodorizing/Dust Collecting Fresh Air In
Filter
Attaching the Nano-Titanium Disinfecting
Deodorizing/Dust Collecting Fresh Air In
Filter Case
• Please hold the
handle of the case
and attach along
the slot, and then
keep pressing until
the case clicks.
• Improper filter
installation may
result in abnormal
noises.
Attaching the Fresh Air In Pre-Filter
• Please hold the handle and install the filter by
pushing it along the inner grooves.
Closing the Front Panel
• Hold the front panel with both hands and pull
forward, then down.
• Keep pressing the front panel in the direction of
the arrow (3 places) until the panel clicks.
Front Panel
• If the front panel is loose, the panel may come off and fall.
• When opening the front panel, please do not use excessive force. If the front panel
comes off the device, this may cause it to malfunction.
• Please do not operate the device without the pre-filter. If dust enters the machine, this
may cause it to malfunction.
• When removing and installing the pre-filter, please take sufficient care not to cut your
hand with the fin of the heat exchanger.
9
7 8
1211
10
CAUTION
Groove
AIR IN PRE-FILTER, EXHAUST PRE-FILTER, NANO-TITANIUM DISINFECTING
Nano-Titanium Disinfecting Deodorizing/Dust
Collecting Fresh Air In Filter (included)
To Next Page
Loading...
