– 14 –
HEATING OPERATION
Press the FUNCTION selector so that the display indicates
(HEAT).
Set the desired FAN SPEED with the (FAN SPEED) button (the display
indicates the setting).
(AUTO) : The FAN SPEED changes automatically according to the
temperature of the air which blows out.
(HI) : Economical as the room will become warm quickly. But you
may feel a chill at the beginning.
(MED) : Quiet.
(LOW) : More quiet.
(SILENT) : Silent.
■ As the settings are stored in memory in the remote controller, you only have to press
the
(START/STOP) button next time.
1
Press the
(HEAT) button. Operation start with a beep at previous HEAT mode.
1
Press the (START/STOP) button.
■ Direct selection
■ Manual selection
STOP
• Use the device for heating when the outdoor temperature is under 21°C. When it is too warm (over 21°C), the
heating function may not work in order to protect the device.
• In order to keep reliability of the device, please use this device above -15°C of the outdoor temperature.
Defrosting will be performed about once an hour when frost forms on the heat exchange of the outdoor unit, for
5~10 minutes each time.
During defrosting operation, the operation lamp blinks in cycle of 3 seconds on and 0.5 second off. The maximum
time for defrosting is 20 minutes. (If the piping length used is longer than usual, frost will likely to form.)
2
Press the (START/STOP) button.
Heating operation starts with a beep.
Press the button again to stop operation.
START
STOP
Set the desired room temperature with the TEMPERATURE buttons (the display
indicates the setting).
The temperature setting and the actual room temperature may vary somewhat
depending on conditions.
3
To Next Page
Loading...
