EasyManua.ls Logo

Hitachi RAC-D10EX2 - Washing and Reattaching Filters

Hitachi RAC-D10EX2
36 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
26
Wash Each of the Removed Filters with
Water
After washing with water, please allow to drip dry.
If the dirt is difficult to wash off, please wash with
luke warm water that does not exceed 40°C.
Do not rub too hard when washing with water.
Nano-Titanium Disinfecting Deodorizing/Dust
Collecting Fresh Air In Filter should wash and dry
in the shade once in every 3 months. Although it
can be washed and used repeatedly, it is
recommended that the filter is replaced every 3
years.
6
Attaching the Nano-Titanium Disinfecting
Deodorizing/Dust Collecting Fresh Air In
Filter Case
Improper filter installation may result in abnormal
noises.
7
MAINTENANCE
Attaching the Fresh Air In Pre-Filter
Please keep the engraved mark up and attach
by pushing the filter into the device until the filter
clicks.
Improper filter installation may result in abnormal
noises.
Attaching the Exhaust Pre-Filter
Please hold the handle and attach the filter by
pushing it along the inner grooves until the filter
clicks.
8
9
Nano-Titanium Disinfecting
Deodorizing/Dust Collecting
Fresh Air In Filter Case
(included)
Close the Front Panel
Hold the front panel with both hands and pull
forward, then down.
Keep pressing the front panel in the direction of
the arrow (3 places) until the panel clicks with
both hands and pull forward, then down.
10
Front Panel
Groove
CAUTION
Do not operate with the duct filter removed.
Dust or odors may infiltrate the room and may cause the device to malfunction.

Related product manuals