(TIME) button to set the current year.
3. Press
(CLOCK) button. "Day" and "Month"
blink.
4. Press
(TIME) button to set the current day and
month.
5. Press
(CLOCK) button. "CLOCK" blinks.
6. Press
(TIME) button to set the clock to the current
time.
7. Press
(CLOCK) button.
Calendar and clock are set.
To modify the calendar and clock, press (CLOCK)
button.
Then follow steps 2 to 7.
Calendar and clock need to be set again after changing
batteries.
After changing the batteries,
1. Press
(RESET) button.
2. Direct remote controller towards indoor unit and press
(INFO) button.
3. The calendar and clock from indoor unit will be transmitted.
■ Calendar and clock will not be transmitted from indoor
unit when the following occurs:
● When there is a power failure.
● When breaker is OFF by user (unit is not in STANDBY
MODE).
NOTE
Note on setting the calendar and clock.
● If the calendar and clock are not set, the ON timer, off timer and Weekly Timer cannot be set.
● If the calendar and clock are not set correctly, the ON timer, off timer and Weekly Timer will not
operate correctly.
● When the ON timer, off timer and Weekly Timer are set, the calendar and clock cannot be changed.
If there is a need to change the calendar and clock, ON timer, timer and Weekly Timer need to
be cancelled.
NAMES AND FUNCTIONS OF REMOTE CONTROLLER
REMOTE CONTROLLER
● This controls the operation of the indoor unit. The range of control is about 7 meters. If indoor lighting is
controlled electronically, the range of control may be shorter.
This controller can be fixed on a wall using the fixture provided. Before fixing it, make sure the indoor unit
● Handle the remote controller with care. Dropping it or getting it wet may compromise its signal transmission
capability.
● After new batter
ies are inserted into the remote controller, the unit will initially require approximately
10 seconds to respond to commands and operate.
● When remote controller is not in use for about 3 minutes during OFF condition, indicated by
on the
display, the LCD will turn off.
● During clock setting, the LCD will turn off about 10 minutes later if the remote controller is not in use.
● When pressing any button, the LCD will turn on.
● The LCD will not turn off during TIMER setting.
Signal Transmitting/Receiving
Window
Point this window towards the
indoor unit when controlling it.
Sensor
A temperature sensor inside the
remote controller senses ambient
temperature around the remote-
controller.
Display
This indicates the room temperature
selected, current time, timer status,
function and airflow rate selected.
ROOM TEMPERATURE setting Buttons
Press these buttons to set the room
temperature.
Press the [
] button to raise the room
temperature.
Press the [ ] button to lower the room
temperature.
Keep pressing and the value will change
more quickly.
Transmission sign
The transmission sign lights up
when a signal is sent.
START/STOP button
Press this button to start
operation. Press it again to stop
operation.
FAN SPEED selector Button
This determines the fan speed. Every
time you press this button, the airflow
rate will change from
(AUTO)
➞ (HIGH) ➞ (MED) ➞
(LOW) ➞ (SILENT) (This
button allows selection of optimal
or preferred fan speed for each
operation mode).
ECO Button
Use this button to set the ECO
( p. 1)
To Next Page
Loading...
