1. While pressing [START
/STOP] button and [ON] button, press [RESET] butt
on at one time.
Stop pressing [RESET] button only and make sure that all marks on the LCD display are indicated,
then stop pressing the [START/STOP] button and [ON] button.
(Enters "Shift Value Change Mode".)
2. Press [MODE] selector button to select FAN mode.
3. Press [START/STOP] button. (FAN operation will be started.)
4. Select the followin
g (FAN speed) to choose required operation mode to
change.
- To change the shift value of COOLING operation, select (HIGH) or (MED) of FAN speed.
- To change the shift value of HEATING operation, select (LOW) or (SILENT) of FAN speed.
HOW TO CHANGE THE SHIFT VALUE FOR SETTING TEMPERATURE
PROCEDURE 1 PROCEDURE 2 PROCEDURE 3 PROCEDURE 4
5. Then Press the TEMPERATURE button to change the shift value.
(The shift value is changed with a beep.)
Please check the transmission sign and a beep.
NOTE :
(1) The indication of the changed shift value and symbol of COOLING or HEATING will disappear
after 10 seconds.
Reduce 3 deg.
from the value
Reduce 2 deg.
from the value
Reduce 1 deg.
from the value
The initial
setting value
Increase 1 deg.
from the value
Increase 2 deg.
from the value
Increase 3 deg.
from the value
(2) The changed shift value will remain unchanged after turned off the power.
(3) When "0" is indicated, the shift value is at the initial setting.
HEATING
is blinking.
COOLING
is blinking.
To Next Page
Loading...
