DISPLAY OPERATION MODE SETTING
This is the remote controller setting method for operating indoor unit independently by display etc.
New communication format(Between indoor and outdoor) is required to communicate with outdoor unit.
So this setting is required in order to operate indoor unit independently.
PROCEDURE
1. While pressing [INFO] button and [COPY/PASTE] button, press [RESE
T] button at
one time.Stop pressing [RESET] button only and make sure that all marks on the LCD display
are indicated, then stop pressing the [INFO] button and [COPY/PASTE] button.
Remote controller enters "DISPLAY OPERATION MODE" for indoor unit independently.
Please check that press [FAN] button and " " blinks.
2. [MODE] select, then press [START/STOP] button.
Indoor unit starts to operate independently operation mode.
NOTE :
(1) During "DISPLAY OPERATION MODE", " " blinks on LCD of remo
te controller.
(2) When operation stops, "DISPLAY OPERATION MODE" is canceled.
" " blinks
" " blinks
10 seconds indicate
To Next Page
Loading...
