EasyManua.ls Logo

Hitachi RAK-25PSEW - Maintenance; Maintenance of Dust Box

Hitachi RAK-25PSEW
142 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
MAINTENANCE
WARNING
Before cleaning, stop unit operation with the remote controller and turn off the circuit breaker.
CAUTION
Do not expose the unit to water as it may cause an electric shock.
For cleaning inside the air conditioner, consult your sales agent.
Avoid using detergent when cleaning the heat exchanger of the indoor unit. Unit failure may result.
When cleaning the heat exchanger with a vacuum cleaner, make sure to wear gloves so as not to injure
your hands on the heat exchanger fins.
Maintenance of dust box
No daily maintenance is required. However, dust amount varies
depending on the environment in which the air conditioner is
used. Check the dust amount in the Dust Box approximately
once every year and throw the dust, if any.
Some type of dust may be accumulated on the rear surface of
the dust catcher.
It is recommended to clean the dust catcher together with the
dust box.
1
Stop the operation with the remote controller
and turn off the circuit breaker.
2
Wash the dust box with water.
If the dirt is stubborn, wash the dust box with warm
water below 40°C.
After washing, dry it in the shade.
3
Turn on the circuit breaker.
Dust box
- 7 -
half
MAINTENANCE (continued)
retliF sselniatS hseM orciM fo ecnanetniaM
No daily maintenance is required. However, filter should be cleaned
if the dirt is noticeable due to the environment in which the air
conditioner is used.
1
Stop the operation with the remote
3
controller and turn off the circuit breaker.
2
.lenap tnorf eht nepO
micro mesh stainless filter
CAUTION
Do not open the front panel during operation.
Be sure to stop the operation first before opening
the front panel.
Hold the lower of the front panel with both hands.
If it is raised further, the front panel may be damaged.
side
After removing 1 screw with a short screw driver(L100,TYPE:PH2×38),
remove the Temperature Display box(Please remove it toward the
direction as illustrated if the WIFI adapter is installed).
Screw
- 8 -
27

Related product manuals