Hitachi RAK-25PSEW - Page 61

5''
200''
200''
1. The product will be considered to
have a go-route error if the limit
switch is detected within 160''
(= 170" - 10":10" is the safety time)
after the dust box side is started.
2. The product will be considered to
have an error when 2 go-route errors
are finalized.
Cleaning settings can be selected by
double-pressing the remote control
unit
1. Reverse the current setting.
Cleaning enabled disabled
2. In the case of an error,
this can cancel the display.
Limit
switch
Initialization
side
Operation lamp
Cleaning lamp
Operation diagram for filter cleaning (error detection 2)
Arrival error (lock)
Power
Product command
Initialization
--> dust box
Dust box -->
initialization
Cleaning initiated
Lit 4 seconds /
off 1 second
1. If the limit switch is not detected 200 "
(= 170" +30":30" is the safety time)
after startup, the product will be considered
to have an arrival error.
2. If the startup-side limit switch is detected
during reversing, the product will stop for
5 seconds and restart itself in the direction
of advance.
3. If 2 arrival errors are finalized, the product
will be considered to have an error.
Operation diagram for filter cleaning (error detection 3)
Lit 4 seconds /
off 1 second
Limit
switch
Initialization
side
Operation lamp
Cleaning lamp
Power
Product command
Initialization
--> dust box
Dust box -->
initialization
Cleaning initiated
Cleaning unit driving motor
Cleaning unit driving motor
(Press the (AUTO SWING
(OK) buttons
simultaneously for 5 seconds.)
VERTICAL) and
55
3. If the filter cleaning operation
is prohibited ,the manual filter
cleaning operation can ues.
18'' 18'' 170'' 170'' 18'' 18'' 170'' 170''
61