4
5
6
How to cancel the preset timer
Press the (CANCEL) button.
(All the preset timer will erase)
•
(OFF TIMER) / (ON TIMER), which are to be set using the clock function,
cannot be set during the operation set by the
(AIR
during the quick laundry or condensation control mode
PURIFYING) buttons or
operation.
under (DEHUMIDIFY)
• As the time settings are stored in memory in the remote controller, just press
the
(PRESET) button in order to use the same settings next time.
Press the
(ON
TIMER) button.
•
(ON TIMER) blinks.
• 6:00 a.m. or the previous preset
time is displayed.
•
display indicates the
sequence of
(OFF TIMER)
and
(ON TIMER) function.
Press the
(TIMER)
button to set the time.
• Time can be set in increments
of 10 minutes.
• The time can be fast-forwarded
by continuously pressing the
button.
Time is incremented
Time is decremented
Press the (PRESET)
button.
• A short beep sounds and the
(ON TIMER) is set.
•
(ON TIMER) indication stops
blinking and lights up.
(TIMER SET) will be
displayed.
• The
(TIMER) indicator on the
indoor unit lights up.
• To change the preset time
for
(ON TIMER), return to
procedure and press the
(ON TIMER) button.
ENGLISH
DEUTSCHFRANÇAISITALIANOSPANISHPORTUGUÊS
∂ÏÏËÓÈο
РУССКИЙ
DEUTSCHFRANÇAISITALIANOSPANISHPORTUGUÊS
∂ÏÏËÓÈο
РУССКИЙ
– 27 –
ENGLISH
2012-2-21 14:51:49
1
2
FURTHER CONVENIENT TIMER FUNCTION
Dehumidifying (Condensation control) operation and
(ON TIMER) for heating operation can be set at the
same time.
Dehumidifying (Condensation control) operation controls the condensation which may occur in the morning
while
(ON TIMER) for heating operation warms up the room by the time you wake up.
Combination of (ON TIMER) and (DEHUMIDIFY) button
• Dehumidifying (Condensation control) operation and (ON TIMER) for heating operation for the next morning
can be set in combination before you go to sleep.
The display below is shown in the case where
(ON TIMER) is set for heating operation and then
dehumidifying operation (Condensation control) is executed at 11:38 p.m.
Preset the
(ON TIMER).
• When
(ON TIMER) is set, the air conditioner starts
operation so that the preset room temperature is
almost reached at the ON TIMER time. Check the
settings of the air conditioners when you set the timer.
(Page 26, 27)
Press the
(DEHUMIDIFY) button.
(
symbol is displayed)
• The dehumidifying (Condensation control) operation
stops at 1:38 a.m, two hours after the start of the
dehumidifying operation, and the heating operation
starts in order to reach the preset temperature by
6:00 a.m.
– 28 –
To Next Page
Loading...
