1
2
SLEEP TIMER OPERATION
Configuring the fan speed appropriate for sleeping and stop the operation at specified time.
The display below indicates sleep timer which is set for 2 hours at 11:38 p.m. and the turn off time will be
1:38 p.m.
Press the (SLEEP) button.
• Every time you press the (SLEEP) button, the mode will change
as shown below.
Cancel the sleep timer
• Preset time of sleep timer and the time at which the operation stops
will be displayed on the remote controller.
• Fan speed remain “SILENT” during sleep timer operation.
CANCEL
Press the (SLEEP) button or (CANCEL) button.
Combination of Sleep Timer and On Timer operation
• Set the operation to auto stop by sleep timer operation, it can be set to start the operation next morning by
(ON TIMER). Set (ON TIMER) first and then press the (SLEEP) button.
The display below indicates
(ON TIMER) which is set at 6:00 a.m. and 2 hours sleep time at
11:38 p.m.
Preset the
(ON TIMER).
(Page 26, 27)
Press the
(SLEEP) button.
• The unit will turn off in 2 hours (at 1:38 a.m.)
and will turn on in order to reach the preset
temperature by 6:00 a.m.
•
The time range of sleep timer operation should
be set before (ON TIMER) time.
• When the sleep timer has been programmed, the unit
will not operate even if the set time is reached unless
the unit receives a signal from the remote controller.
Confirm that Sleep Timer programming is complete
(beep) and the
(TIMER) indicator of the indoor unit
turns on.
DEUTSCHFRANÇAISITALIANOSPANISHPORTUGUÊS
∂ÏÏËÓÈο
РУССКИЙ
– 29 –
ENGLISH
2012-2-21 14:51:50
1
FILTER CLEANING OPERATION
(Filter Cleaning Unit Operation Check, page 10)
CAUTION
Do not put your fingers or a stick etc into the top part of the indoor unit during filter cleaning
operation.
It may result in injury or malfunction.
Automatic filter cleaning operation
• Automatically cleans the micro mesh stainless filter when the basic air-conditioning operation such as
cooling has ended. (Refer to page 31 for automatic filter cleaning operation)
• Automatic filter cleaning mode is set at the time of purchase.
Forward movement
Sweeps and collects the dust on the
micro mesh stainless filter.
Dust catcher
(1) Cleaning unit collects the dust
swept by the cleaning unit on
its forth movement.
(2) It turns over by the travelling
force of the cleaning unit which
is travelling back. At this time,
the dust collected by the dust
catcher is put into the dust
box.
Backward movement
Once the filter cleaning operation has been
completed, the cleaning unit returns to the
position at which air conditioning operation
is not obstructed.
– 30 –
To Next Page
Loading...
