– 6 –
NAMES AND FUNCTIONS OF EACH PART
REMOTE CONTROLLER
• This controls the operation of the indoor unit.
The range of control is about 7 meters. If indoor lighting is controlled electronically, the range of
control may be shorter, in some cases, the control signal may not be received.
This unit can be fixed on a wall using the fixture provided. Before fixing it, make sure the indoor unit
can be controlled from the remote controller.
• Handle the remote controller with care.
Dropping it or getting it wet may compromise its signal transmission capability.
• After new batteries are inserted into the remote controller, the unit will initially require approximately
10 seconds to respond to commands and operate.
Precautions for Use
• Do not put the remote controller in the following places.
• In direct sunlight
• In the vicinity of a heater.
• Handle the remote controller carefully. Do not drop it on the floor, and
protect it from water.
• Once the outdoor unit stops, it will not restart for about 3 minutes (unless
you turn the power switch off and on or unplug the power cord and plug
it in again).
This is to protect the device and does not indicate a failure.
• If you press the FUNCTION selector button during operation, the device
may stop for about 3 minutes for protection.
Signal Transmission
Use this button to select the
operating mode. Every time
you press it, the mode will
change from
Transmission Sign
The transmission sign blinks
when a signal has been send.
POWERFUL Button
Press this button to start
powerful operation. ( Page 1 2 )
TEMPERATURE Button
Room temperature setting.
Value will change quicker when
keep pressing.
FAN SPEED Button
Select the fan speed for cooling
and heating mode.
( Page 1 1 )
AUTO SWING（Horizontal)
Button
Control the angle of the
horizontal air defl ector.
( Page 1 5 )
AUTO SWING（Vertical)
Button
Control the angle of the
vertical air defl ector.
(Page 1 5 )
(AUTO) to
(COOL) to (HEAT)
(DEHUMIDIFY) and
FUNCTION selector
to
(FAN)
cyclically.
to
SLEEP button
Use this button to set the sleep
timer.
ECO Button
Use this button to set the ECO
mode.
(
Page 1 3)
OFF TIMER Button
Select the turn OFF time.
( Page 1 2 )
ON TIMER Button
Select the turn ON time.
( Page 1 2 )
START/STOP button
Press this button to start operation.
Press it again to stop operation.
(
Page 7)
(
Page 1 )4
To Next Page
Loading...
