8 Troubleshooting
307
SMGB0087 rev.0 - 12/2013
8
Transistor module checking procedure
Outer Appearance and Internal Circuit of Transistor Module
1. Drive circuit.
2. Overheating protection circuit.
3. Sensor.
1
1
1
1
1
1
1
2
3
Procedure:
Remove all the terminals of the transistor module before check. If items [1] – [4] are performed and the results are satisfac-
tory, the transistor module is normal.
Measure it under 1kΩ range of a tester.
N O T E
DO NOT use a digital tester.
1 By touching the + side of the tester to the P terminal of transis-
tor module and the - side of tester to U, V and W of transistor
module, measure the resistance. If all the resistances are from 1
to 5kΩ, it is normal.
2 By touching the - side of the tester to the P terminal of transis-
tor module and the + side of tester to U, V and W of transistor
module, measure the resistance. If all the resistances are greater
than 100kΩ, it is normal.
3 By touching the - side of the tester to the N terminal of transis-
tor module and the + side of tester to U, V and W of transistor
module, measure the resistance. If all the resistances are from 1
to 5kΩ, it is normal.
4 By touching the + side of the tester to the N terminal of transis-
tor module and the - side of tester to U, V and W of transistor
module, measure the resistance. If all the resistances are greater
than 100kΩ, it is normal.
To Next Page
Loading...
