Hitachi RAS-(3-6)HVNC1(E) - Page 385

10 Servicing
371
SMGB0087 rev.0 - 12/2013
10
10.3.16 Removing other electrical components
1 Remove the service cover following “10.3.1Removingservicecover”in this chapter.
2 Open the P plate turning counter clockwise approximately 90° following “10.3.9Openingelectricalbox(Pplate)”.
• Check that the LED201 (red) on Inverter is OFF when the P plate is opened.
CMC
1 Remove all the wiring connected to CMC.
2 Remove 2 screws xing the CMC.
Reactor
1 Remove 4 screws xing the reactor.
Noise lter
1 Remove all the wiring connected to the noise lter.
2 Hold the upper part of the 6 holders with the long nose pliers
and remove the noise lter.
Holder
Long-Nose Pliers
Noise Filter
Holder
Noise lter
Long nose pliers
Fuse
Noise lter
Reactor
CMC
Holders
Screws
Holders
Screws
N O T E
• Toconnectwiringatreassembling,ensurethattheterminalnumbersandwiringmarkbandcodesarematched.Ifcon-
nectionsarewrong,thereisthepossibilityofwrongoperationandtocausedamagetoelectricalparts.
• WhenattachingthePCB,orwhenattachingthepartsattachedtothePCB,payattentionnottoclampanywiringbet-
weenplatesorelectricalcomponents.