Hitachi RAS-(3-6)HVNC1(E) - Page 412

10 Servicing
398
SMGB0087 rev.0 - 12/2013
10.6 RAS-12HNP
10.6.1 Removing service cover
N O T E
• Follow the procedure below to remove main parts and components. For mounting follow the reverse procedure of
removal.
• Donotexposetherefrigerantcycletotheatmosphereforalongperiodtoavoidmoistureordustenteringintothecycle.
Besuretoreplacepartsimmediatelyafterremoving.Sealtherefrigerantcyclewhenleftunattachedforalongperiod.
1 Remove the 5 xing screws, slide the service cover downward and
remove it.
• Pay attention not to fall off the service cover.
Service
cover
10.6.2 Removing air outlet grille
1 Remove the 8 xing screws of the shroud.
Air Outlet Grille
Air Outlet Grille
Shroud
Air outlet grille
Shroud
Air outlet grille