Hitachi RAS-(3-6)HVNC1(E) - Page 453

10 Servicing
439
SMGB0087 rev.0 - 12/2013
10
10.9 RAS-12HNC
10.9.1 Removing service cover
N O T E
• Followtheprocedurebelowtoremovemainpartsandcomponents.
Formountingfollowthereverseprocedureofremoval.
• Do not expose the refrigerant cycle to the atmosphere for a long
period to avoid moisture or dust entering into the cycle. Be sure to
replace parts immediately after removing. Seal the refrigerant cycle
when left unattached for a long period.
1 Remove the 5 xing screws, slide the service cover downward and
remove it.
• Pay attention not to fall off the service cover.
Service
cover
10.9.2 Removing air outlet grille
1 Remove the 8 xing screws of the shroud.
Air Outlet Grille
Air Outlet Grille
Shroud
Air outlet grille
Shroud
Air outlet grille