Press Timer ON button once. or Timer OFF button
Clock symbol stop blinking and Clock time will be display on LCD
screen.
● When Timer ON , Timer OFF or both set then it is not possible to change/set clock time. First Timer ON ,
Timer OFF or both need to cancel.
● If Correct clock time is not set then Timer ON and Timer OFF will not operate correctly.
● At time of Battery replacement/ Reset , Clock time need to set. If it is not set and press any key then default
12:00 will be set.
● At time of Battery replacement / Reset , Need to follow process from step2 onwards.
● symbol is blinking , if no key press then it will come out of Clock During Clock time change/set when
setting with previous set time.
or Timer OFF button for Press and Hold Timer ON button
5 seconds.
segment start blinking on LCD approx. 5 seconds then
symbol start blinking.
or
Clock
When Clock symbol is in blinking , Press Temperature Up / Down
button to change/set desire time value.
How to set clock
1
2
3
How
to Install
the Batteries in the Remote Controller
1
2
Remove the cover as shown in the figure and take out the old batteries.
Install the new batteries.
The direction of the batteries should match the marks in the case.
1. Do not use new and old batteries, or different kinds of batteries together.
2. Take out the batteries when you do not use the remote controller for 2 or 3 months.
CAUTION
Push and pull to the
dirction of arrow
Batteries
Cover
NOTE
●
Change the batteries when remote controller LCD display restarts on pressing of any key and there is
no response from air conditioner.
To Next Page
Loading...
Need help?
General
