Hitachi RC-AGU1EA0G - Fan Mode Operation; Fan Mode Details; Timer Reservation; Setting the Off Timer

User can use the device simply as an air circulator.
START
STOP
1
2
Press the M selector button so that the display indicates
(F ).
Press the
button. Fan operation starts with a beep.
Press the button again to stop operation.
Press the
button.
Timer Reservation
• Select the Off Time by pressing the
Button.
• Setting time will change according to the below
sequence when you press the button.
Timer and
Timer are available.
2
1
On Time setting
• Select the On Time by pressing the Button.
• Setting time will change according to the below
sequence when you press the button.
Operation stop at setting time
Operation will start
setting
temperature at setting time.
Fan Speed
(S ) (L ) ( )
(High)
(Super High)
On Timer
Off Timer
On Timer
Set Temp. -0.5Hr. -1.0Hr. -2.0Hr-3.0Hr.......... -10.0Hr. -11.0Hr -12.0Hr.
Set Temp. -0.5Hr. -1.0Hr. -2.0Hr-3.0Hr.......... -10.0Hr. -11.0Hr -12.0Hr.
- 7 -
Off Time setting
NOTE
・During setting timer, if you do not press any button for 3 seconds then it will come out of setting timer mode
with preset time.
And On Timer icon " " or Off Timer icon " " will remain on LCD to indicate timer setting.
・During setting timer, if you press active button then it will come out immediately with timer setting.
・Timer On and Timer Off can be set simultaneously.
・When both timer set simultaneously then arrow " " mark will appear on LCD appear near " " or " "
which will execute first.
・On Timer or Off Timer can be canceled without long scrolling by pressing On Timer and Off Timer button
together for 3 seconds.
Cancel OFF Timer
Cancel ON Timer