2.3 Necessary Tools and Instrument List for Installation
3. Transportation and Handling
3.1 Transportation
x
Transport the product as close to the installation
location as practical before unpacking.
x
Do not put any material on the indoor unit.
x
The indoor unit is packed upside down against
the installation direction and the foamed
polystyrene drain pan is exposed to the upper
side. Do not put the indoor unit with the
drain pan downward during the process from
unpacking the indoor unit until hanging up the
unit to a ceiling. In addition, do not handle the
indoor unit with the drain pan portion or the air
outlet portions.
x
Pay attention to handle the indoor unit. If an
excessive force is applied to the indoor unit, it
may cause a breakage because the indoor unit
is adopted the foamed polystyrene.
3.2 Handling of Indoor Unit
NOTE
About vacuum pump, gas hose, charging cylinder, gauge manifold, please use suitable
equipments for using the refrigerant respectively. Do not mix other refrigerant.
Do not put any material on the product or the
air panel.
Do not step on the product.
Do not hold the resin covers when holding or
lifting the indoor unit.
Do not put any foreign material into the indoor
unit and check to ensure that no foreign
material exists in the indoor unit before the
LQVWDOODWLRQDQGWKHWHVWUXQ2WKHUZLVHD¿UH
or failure, etc. may occur.
x
To avoid damage to the resin covers, before
lifting or moving the indoor unit, put a cloth on
the resin covers.
No. Tool No. Tool
1 Handsaw 11 Spanner
2 Phillips Screwdriver 12 Charging Cylinder
3 Vacuum Pump 13 Gauge Manifold
4 Refrigerant Gas Hose 14 Cutter for Wires
5 Megohmmeter 15 Gas Leak Detector
6 Copper Pipe Bender 16 Leveller
7 Manual Water Pump 17 Clamper for Solderless Terminals
8 Pipe Cutter 18 Hoist (for Indoor Unit)
9 Brazing Kit 19 Ammeter
10 Hexagon Wrench 20 Voltage Meter
21
Wrench
To Next Page
Loading...
