Need help?Do you have a question about the Hitachi RWD-2.0NRWE-200S and is the answer not in the manual?
General| Model | RWD-2.0NRWE-200S |
|---|---|
| Category | Heat Pump |
| Cooling Capacity | 2.0 kW |
| Refrigerant | R410A |
| Power Supply | 220-240V, 50Hz |
| Noise Level (Outdoor) | 48 dB |
Explains symbols used in the manual for warnings and important information.
Details the classification of YUTAKI units and provides a product list.
Provides crucial safety warnings, DANGER, and CAUTION notices for equipment handling.
Highlights critical instructions for installation, use, and general operation.
Explains key terms and conditions for understanding electrical specifications like voltage and current.
Covers electrical specifications for R410A/R32 outdoor and indoor split YUTAKI units.
Details electrical specifications for YUTAKI M monobloc units.
Defines the nominal, operating, and starting voltage ranges for the YUTAKI system.
Outlines operational temperature limits for YUTAKI units across various modes like heating, DHW, and cooling.
Details hydraulic data, flow rates, and pump performance curves for YUTAKI units.
Covers notes, piping lengths, charge, area requirements, and size for R32 refrigerant systems.
Addresses piping, precautions for leaks, charge, and size for R410A refrigerant systems.
Details water piping lengths, sizes, quality recommendations, and flow control for YUTAKI systems.
Covers general checks for power supply adequacy, voltage stability, and impedance compliance.
Specifies required wire sizes for power supply, transmitting, and actuator cables based on current ratings.
Details minimum requirements for circuit breakers (CB) and earth leakage breakers (ELB) for unit protection.
Illustrates main power supply and communication wiring connections to terminal boards TB1 and TB2.
Explains the controller's display, buttons, common icons, and view-specific icons.
Guides through initial setup via Configuration Assistant, advanced settings, and menu structure.
Explains the interface, buttons, common icons, and view-specific icons for the cascade controller.
Guides through cascade configuration assistant, advanced settings, and menu navigation.
Lists and explains common alarms for indoor units, their details, and main contributing factors.
Lists and explains common alarms for the cascade controller, their details, and main factors.
Lists and explains common alarms for outdoor units, their types of abnormality, and main causes.
Lists and explains common alarms related to the LCD display and communication.
Covers initial cautions, and general maintenance procedures for outdoor and indoor units.
Details the periodic checks for the outdoor unit's components and connections.
Details periodic checks for the indoor unit's cabinet, water piping, and electrical parts.
Covers inspection hatch, filter, safety valve, air purger, pump, descaling, and draining procedures for key components.
To Next Page
