Hitachi SJ Series - Page 31

4.2 External

Chapter 4
4.2 External

How to check the external appearance.
Q
Operator keypad
A removable liquid crystal panel (VOP).
The POWER and RUN lamps are on it.
Terminal block cover
Optional cassette installed
A maximum of three optional cassettes can be
installed. (In
Control circuit terminal block
Sends a command to the inverter and issues an
alarm. Internal data can be imported into the external
device through Ao or FM output
Main circuit terminal block
Connects the power supply and motor. This is also
used for connecting optional devices including
reactor.
Front cover
Chapter 4
4.2 External
Appearance of the Product
How to check the external appearance.
Operator keypad
A removable liquid crystal panel (VOP).
The POWER and RUN lamps are on it.
Terminal block cover
Optional cassette installed
A maximum of three optional cassettes can be
installed. (In
preparation)
Control circuit terminal block
Sends a command to the inverter and issues an
alarm. Internal data can be imported into the external
device through Ao or FM output
Main circuit terminal block
Connects the power supply and motor. This is also
used for connecting optional devices including
Front cover
Appearance of the Product
How to check the external appearance.
Product’s main body
A removable liquid crystal panel (VOP).
The POWER and RUN lamps are on it.
Terminal block cover
Optional cassette installed
A maximum of three optional cassettes can be
preparation)
Control circuit terminal block
Sends a command to the inverter and issues an
alarm. Internal data can be imported into the external
device through Ao or FM output
terminal.
Main circuit terminal block
Connects the power supply and motor. This is also
used for connecting optional devices including
Appearance of the Product
Product’s main body
A removable liquid crystal panel (VOP).
The POWER and RUN lamps are on it.
A maximum of three optional cassettes can be
Control circuit terminal block
Sends a command to the inverter and issues an
alarm. Internal data can be imported into the external
terminal.
Connects the power supply and motor. This is also
used for connecting optional devices including
Backing plate
4-2

The cover is
*
An example of P1
A
alarm. Internal data can be imported into the external
Backing plate
The cover is
attached
An example of P1
A
Product’s main body
(with a front cover opened)
Main Body of the Product
attached
at factory shipment.
An example of P1
-00330-
LFF
Specification label
Heat sink
Product’s main body
(with a front cover opened)
Main Body of the Product
at factory shipment.
LFF
(P1-
055LFF)
Specification label
Heat sink
Product’s main body
(with a front cover opened)
Main Body of the Product
055LFF)
Specification label
Main Body of the Product