To Next PageTo Next Page
Need help?Do you have a question about the Hitachi SJ200 Series and is the answer not in the manual?
General| Series | SJ200 |
|---|---|
| Category | Inverter |
| Output Frequency | 0.1 to 400 Hz |
| Overload Capacity | 150% for 60 seconds |
| Cooling Method | Fan cooled |
| Humidity | 5 to 95% RH (non-condensing) |
| Control Method | V/f Control, Sensorless Vector Control |
| Protection | Overcurrent, Overvoltage, Undervoltage, Overheat |
| Ambient Temperature | -10 to 50°C |
| Braking Unit | Built-in |
| Communication | RS-485 (Modbus RTU) |
| Altitude | Up to 1000m |
| Output Voltage | 3-Phase 200-240 VAC, 3-Phase 380-480 VAC |
| Storage Temperature | -20 to +60°C (-4 to 140°F) |
Details high voltage precautions and safe practices for handling electrical shock.
Provides warnings and cautions for electrical practices, wire usage, and specifications.
Details warnings about operating the inverter energized, touching terminals, and potential hazards.
Lists general warnings and cautions applicable to troubleshooting and maintenance tasks.
Summarizes procedures for inverter installation to comply with Underwriters Laboratories guidelines.
Explains the built-in solid state motor overload protection and parameter settings.
Provides a sequential guide for the basic installation steps of the inverter.
Details the procedure for performing the initial powerup test of the inverter and motor.
Provides guidance and safety messages for troubleshooting inverter and motor system issues.
