10
English
By adjusting the dial, match the speed to the material and type of work.
Material
Grain
Dial scale
Rough grinding Fine grinding
Paintwork:
Sanding 180 400 3 – 6
Repairs
(scratches, rust spots) 120 240 2 – 4
Stripping 40 80 2 – 4
Wood:
Softwood 60 – 80 240 3 – 6
Hardwood 60 180 3 – 5
Veneers 240 320 2 – 4
Metals:
Aluminium 80 240 2 – 4
Steel 60 240 3 – 6
Stainless steel 120 240 3 – 6
NOTE: Please use this table as a standard.
NOTE:
When placing the dust bag on the tool,
be sure that the raised rib on the dust bag
aligns with the groove on the sander and
that the dust bag snaps into place properly.
Improper attachment of the dust bag can
cause damage to internal components.
8. Adjustment of speed
The sander is equipped with the electric
control circuit which enables non-step
speed control. To adjust the speed, turn
the dial shown in Fig. 5. When the dial
is set to “1”, the sander operates at the
minimum speed (9,000/min). When the
dial set to “6”, the sander operates at the
maximum speed (13,000/min). Adjust the
speed according to the material to be cut
and working effi ciency.
Fig. 5
Dial
000BookSV13YST.indb10000BookSV13YST.indb10 2017/07/109:01:142017/07/109:01:14
To Next Page
Loading...
Need help?
General
