English
13
PICTGRAPH ILLUSTRATION AND EXPLANATION
Read handling
instructions before
use.
Avoid any work exceeding the
maximum capacities.
(Rebar diameter: #5 (5/8"))
Do not this electric
power tools in wet
wether conditions.
Begin operation only after
ensuring that there are no
people within the turning
range of the material to
be bent.
Never bring your
hand close to the
cutter during
operation.
If the switch is turned off and then
immediately turned on again, the
motor may not start. Wait for at least
one full second before attempting to
turn the motor on again after it has
been switched off.
(Returning Halfway)
1 Select RETURN with the dial.
2 Pull the triger.
(Selecting the rebar size)
Select the rebar size and
the bending angle.
To Next Page
Loading...
