Hitachi VSP E990 - Install Hitachi VSP E990: Register with Support; Install Hitachi VSP E990: Install Remote Ops Monitoring

To Next Page

To Previous Page

2. Connect your Gigabit Ethernet network switch to the NIC or HBA card in each host computer or server.

Step 11: Register your storage system with Hitachi Vantara Support

If you do not already have an account on the Support Website, you will need to register. Otherwise, you will not be able

to download and install the Hitachi Remote Ops monitoring system.

Before you begin

• Register an account on the Support Website.

Procedure

1. Locate the product serial number (labeled MFG. NO.) on the rear of the controller. You will need this number to

2. Open a web browser on your PC or mobile device.

3. Log in to the Support Website, and follow the instructions to register your storage system. If you have previously

registered Hitachi Vantara products, you can add an additional site.

Step 12: Install Hitachi Remote Ops monitoring system

Hitachi Remote Ops monitoring system monitors your storage system and notifies Hitachi Vantara when service is

required. Hitachi Remote Ops runs on Windows, Linux, and Solaris operating systems.

Before you begin

• Log in to the Support Website. If you do not already have an account, you need to register. When registering, you

will be asked for information about the product. For Product Name, enter VSP E Series. The product serial number

is labeled MFG. NO. on the rear of the controller.

• Obtain the Site ID for the location at which the storage system is installed. If you do not see your site listed, you will

first need to add the site.

Procedure

1. Download the Hitachi Remote Ops system software and documentation.

2. Follow the instructions in Hitachi Remote Ops Installation Guide to intall and configure Hitachi Remote Ops.

3. After you have configured Hitachi Remote Ops with the appropriate Site ID, open a case on the Support Website

to let us know that your system is installed and that the Hitachi Remote Ops monitoring system is enabled.

Installing Hitachi Remote Ops completes the self-installation of your storage system.

https://knowledge.hitachivantara.com/Documents/Storage/VSP_E_Series/93-06-0x/Installation/Installing_your_VSP_E990_st…

Updated: Wed, 12 Jan 2022 17:18:35 GMT

Other manuals for Hitachi VSP E990