independent process to the terminal LOGOFF, use the "RUN /DETACHED"
command.
3. Confirm the configuration.
Set the log directory (HORCC_LOG) in the command execution
environment as required.
Note: If the log directory under SYS$POSIX_ROOT is shared with other
nodes, the log directory of Horc Manager must be set for each node. The
log directory of Horc Manager can be changed by setting the parameter of
horcmstart. See the Command Control Interface Command Reference for
information about horcmstart parameters.
If you want to perform ShadowImage operations, set the environment
variable (HORCC_MRCF). $ HORCC_MRCF:=1 $ pairdisplay -g xxxx
xxxx = group name
Note: If a system configuration change or a RAID configuration change
causes this file to change, (for example, cache size change or microcode
change), these changes will not take effect until you stop HORCM
(horcmshutdown) and restart HORCM (horcmstart). Use the "-c" option of the
pairdisplay command to verify that there are no configuration errors.
Two instances
To start up two instances of CCI on an OpenVMS system:
1. Create the configuration definition files.
For a new installation, use the configuration definition sample file that is
supplied (SYS$POSIX_ROOT:[HORCM.etc]horcm.conf). Copy the file
twice, once for each instance.
$ COPY SYS$POSIX_ROOT:[HORCM.etc]horcm.conf SYS
$POSIX_ROOT:[etc] horcm0.conf
$ COPY SYS$POSIX_ROOT:[HORCM.etc]horcm.conf SYS
$POSIX_ROOT:[etc] horcm1.conf
Edit these two files according to your system configuration using a text
editor (for example, eve).
Register the port name (service) of the configuration definition file in "SYS
$SYSROOT:[000000.TCPIP$ETC]SERVICES.DAT".
horcm0 xxxxx/udp xxxxx = port number horcm1 yyyyy/udp yyyyy =
port number
Each instance should have a unique port number.
The port number can be directly specified without registering it in "SYS
$SYSROOT:[000000.TCPIP$ETC]SERVICES.DAT".
2. Execute the HORCM startup command.
$ spawn /nowait /process=horcm0 horcmstart 0 $ spawn /
nowait /process=horcm1 horcmstart 1
Note:
The subprocess (HORCM) created by SPAWN is terminated when
the terminal is LOGOFF or the session is terminated. If you want an
Starting up CCI
4-5
Command Control Interface User and Reference Guide
To Next Page
Loading...
Need help?
General