How to troubleshoot Hitachi Air Conditioner hydraulic alarm flow and water pump malfunction?
If your Hitachi Air Conditioner displays a hydraulic alarm related to flow and water pump malfunction, check the water pump for proper operation and repair or replace it if defective. This alarm indicates that water flow is not detected in the hydraulic cycle or the pump is defective.
What causes Hitachi Air Conditioner to activate safety device from excessively low suction pressure?
If your Hitachi Air Conditioner activates the safety device from excessively low suction pressure, inspect refrigerant levels and piping for blockages. This issue is often due to a shortage or leakage of refrigerant, piping clogging, a closed expansion valve, or a locked fan motor.
Why does my Hitachi Air Conditioner activate safety device from excessively high discharge pressure?
If your Hitachi Air Conditioner activates the safety device due to excessively high discharge pressure, inspect the heat exchanger and refrigerant conditions. This activation can be caused by overload (obstruction of HEX, short circuit), a mixture of inert gas, or excessive refrigerant.
What to do if Hitachi Air Conditioner shows abnormal transmission between outdoor and indoor units?
If your Hitachi Air Conditioner shows 'Abnormal transmission between outdoor and indoor units', check the wiring, terminals, and PCB for faults. This issue can be caused by incorrect wiring, loose terminals, PCB failure, a tripped fuse, or the power supply being OFF.
Covers critical safety warnings, including DANGER and CAUTION statements for proper unit operation and handling.
Illustrates refrigerant and hydraulic circuits for YUTAKI split and monobloc systems, detailing component connections.
Covers refrigerant piping length and size requirements, and water piping connections with quality recommendations.
Outlines electrical checks, wiring sizes, connections, and minimum protection device requirements for YUTAKI units.
Guides users through the initial setup process of the unit controller using a wizard, covering language and configuration methods.
Details alarm codes for remote control, indoor units, outdoor units, and LCD display for YUTAKI systems.
To Next Page
General