HITEC X1 AC Plus - Page 27

27
Save Data Program (cont.)
Load Data Program
LithiumSave/Load Data
Press the ► button again and the voltage rate value
will begin  ashing. Use the ✚ or
▬
buttons to set the
voltage rate and cell count. The cell count will change automatically as you
change the voltage. The voltage and cell count should match the battery label.
Press and hold the ► button and this pro le will be saved.
Press the ■ button repeatedly until you reach the “
LOAD DATA“ program. Press
the ► button to enter the program. When you enter the program, the pro le
number will be  ashing. Use the ✚ or
▬
buttons to choose which pro le (1-5)
you wish to load.
Press and hold the ► button and the pro le will be loaded.
LiPo CHARGE *
5.4A 7.4V(2S)