Need help?Do you have a question about the HITEC X1MF and is the answer not in the manual?
General| Output Current | 0.1-10A |
|---|---|
| Charging Power | 100W |
| Discharge Circuit Power | 10W |
| Battery Types Supported | LiPo, LiFe, LiIon, NiMH, NiCd, Pb |
| LiPo/LiFe/LiIon Cell Count | 1-6 cells |
| NiMH/NiCd Cell Count | 1-15 cells |
| Pb Battery Voltage | 2-20V |
| Display | LCD |
| Cooling System | Fan |
| Input Voltage | 11-18V DC |
| Discharge Current Range | 0.1-1.0A |
| Charging Modes | Balance Charge, Fast Charge, Storage, Discharge |
Auto adjusts current during charge/discharge, prevents overcharging.
Employs individual cell voltage balancer, no third-party balancer needed.
Monitors and balances each cell individually, terminates if voltage is abnormal.
Covers unattended operation, environmental conditions, and prohibited batteries.
Verifies battery type, voltage, current, and connection security.
Warns about deep discharge for Lithium batteries and proper charging practices.
Verify battery type, voltage, charge rate; connect charger first.
Critical polarity connection for balancing board to charger.
Uses red rotary push button dial and black Mode/Stop button.
Scrolls menus, adjusts parameters, commits, begins processes.
Exits menus, stops processes, accesses root menu.
For 3.7V/3.6V/3.3V cells, uses CC/CV method.
Preferred for multi-cell packs; monitors individual cell voltages.
Reverse polarity, connection break, connect error, balance error.
DC input voltage too low or too high.
Low/high voltage, invalid voltage, incorrect cell number detected.
Internal/external temp high, capacity/time limits reached.
To Next Page
