EasyManua.ls Logo

HITEC X1 AC Plus - Warnings and Safety Notes (Page 5); Batteries to Avoid Charging;Discharging; Pre-Charging Safety Checks

HITEC X1 AC Plus
36 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
5
A Never attempt to charge or discharge the following types of batteries:
A battery  tted with an integral charge circuit or a protection circuit
A battery pack which consists of di erent types of cells (including dif-
ferent manufacturers cells)
A battery that is already fully charged or just slightly discharged and
non-rechargeable batteries (these pose an explosion hazard)
A faulty or damaged battery
Batteries installed in a device or which are electrically linked to other
components
Batteries that are not expressly stated by the manufacturer to be suit-
able for the currents the charger delivers during the charge process
PLEASE BEAR IN MIND THE FOLLOWING POINTS BEFORE YOU
COMMENCE CHARGING:
Did you select the appropriate program suitable for the type of battery you
are charging?
Did you set up the adequate current for charging or discharging?
Have you checked the battery voltage? Lithium battery packs can be wired
in parallel and in series, i.e. a 2-cell pack can be 3.7V (in parallel) or 7.4V (in
series).
Have you checked that all connections are  rm and secure?
Make sure there are no intermittent contacts at any point in the circuit.
Warnings and Safety Notes

Related product manuals