HITROL HLT-1110 Series

Need help?

Do you have a question about the HITROL HLT-1110 Series and is the answer not in the manual?

Summary

Overview

Operating Principles

Characteristics

Specification

Product Configuration and Technical Data

HLT-1110 Series for Cone Roof Tank

Illustrates the configuration of the HLT-1110 Series for cone roof tanks, showing components like top anchor and float.

HLT-1110 Series for Underground Tank

Details the installation configuration of the HLT-1110 Series for underground tanks, including gauge support and stanchion pipe.

HLT-1110 Series for Floating Tank

Shows the HLT-1110 Series configuration for floating tanks, highlighting the measuring wire and gauge head placement.

HLT-1110 Series for with U-Seal Pot

Depicts the HLT-1110 Series setup for tanks using a U-Seal pot, emphasizing sealing liquid considerations.

HLT-1110 Series for with Guide Pipe

Illustrates the HLT-1110 Series installation with a guide pipe, detailing nozzle socket and flange connections.

Part Name and Dimensions

Gauge head

Provides detailed dimensions and internal component layout of the HLT-1110 Series gauge head, including sprocket and tape drum.

Sheave Elbow

Details dimensions for Aluminum (AL) and Stainless Steel (SUS) sheave elbows used in the HLT-1110 Series.

Top Anchor

Specifies dimensions for the top anchor component used in the HLT-1110 Series installation.

Pipe Support

Provides dimensions for the pipe support used for mounting the HLT-1110 Series gauge.

U-bolt

Shows dimensions for the U-bolt component, typically used for securing pipes in the HLT-1110 Series installation.

Gauge Support

Details dimensions for the gauge support used to mount the HLT-1110 Series gauge head on the tank wall.

Installation

Conditions for Installation and Adjustment

Outlines prerequisites and conditions necessary for the proper installation and adjustment of the HLT-1110 Series gauge.

Guide wire Installation

Details the step-by-step procedure for installing the guide wire, including securing it to the top anchor and bottom anchor.

Measuring Tape Installation (Head Part)

Explains the process of installing the measuring tape into the sheave elbow and gauge head components.

Measuring Tape Installation (Float Part)

Describes how to fold and attach the end of the measuring tape to the float using a tape clamp and joint shaft.

Spring Installation

Gauge Adjustment and Completion

Installation Summary

Precautions for Installation

Pipe Material

Specifies requirements for pipe material (galvanized or stainless) and bending tolerance for HLT-1110 Series installation.

Float Installation Site

Top Anchor Installation Cautions

Gauge Support

Gauge Head

Gauge Operation

Maintenance

Other Precautions

Precautions While Using

Provides essential precautions for using the HLT-1110 Series, including checks before disconnection and proper sealing.

Disposal of the Product

Advises on proper procedures for discarding the product and warns against causing serious impact during handling.

Marking

Product Identification

Explains the product identification mark on the housing, detailing model name, serial number, and operating parameters.

Model Notation

Warranty and Contact Information