Display Interface:
Instructions:
-On/off
Press the power button to turn on and off the machine, press the button,
the locked position is the power on state, press again, the button
bounces
Out position is off;
-Switch gears
Short press (<1 second) the function button to switch the speed gears.
There are 3 gears (MODE 1:1, MODE 2:2,MODE 3： 3 gears)
-Turn on/off headlight
Press the M button two times to turn on/off headlight,
-Switch the display omteirt of the mileage area
The single mileage is displayed by default after power-on. Long press
(>3 seconds) the function button to cycle through the display content of
the mileage area. Single mileage (TRIP) -> accumulated mileage (ODO) ->
fault code (ERR) -> battery voltage (UXX.X)
Note: Each time you turn off the machine and turn it on again, the single
mileage will be reset to zero, and the accumulated mileage will continue
to accumulate
-Fault code display
When a fault is detected, the "ERR" icon will be displayed. At this time,
press and hold the function button (>3 seconds) to switch the check
Look at the current fault code, please refer to the attached table for the
meaning of the feult code
-Battery under-voltage
When the battery under-voltage is detected, the under-voltage (chaining)
sign will be displayed on the screen, a nd the car can still ride for a
certain distance.
Away, but it is recommended to charge immediately.
⑹
To Next Page
Loading...
