HITWAY BK7 - Front Cover and Handlebar Mounting

4. Fasten the top cover screw plug.
5. Remove the 4 front cover screws with the No. 4 Allen key
in the 16-in-1 tool and remove the tube front cover.
6. Place the handlebar into the tube and center the
handlebar angle.Then close the front cover.
NOTE: Do not twist the wire harness.
7. Use the No. 4
Allen key in the
16-in-1 tool to
gradually tighten the
4 front cover screws
in the order shown
in the picture.
4
5
6
7
-3-