HITWAY BK7 - Install the Rear Fender; Rear Fender Support Rod Attachment; Install the Pedals; Pedal Identification and Right Pedal Installation

5. Install the Pedals
4. Install the Rear Fender
1 2
1. Use the No. 4 Allen wrench in the 16-in-1 tool to
remove the fixing screws of the mud plate support rods
pre-installed on the left and right sides of the frame.
2. Fix the rear fender support rods to the
corresponding screw holes of the frame
and use the No. 4 Allen key in the 16-in-1
tool to tighten the screws.
The "R" marked on the pedal shaft means the right
pedal, and the "L" mark means the left pedal.
-8-