21
2.2 Step 2:
2.2.1 Before reinstalling a cover of battery box on a support, please lightly tighten screw B (Fig. 3) so that
a cover of battery box will not shake while embedding the whole device.
2.2.2 Lock up slider (A) , and ensure it is completely and firmly installed on the whole device (Fig. 4).
2.3 Step 3:
2.3.1 Finally, please turn the EMERGENCY switch clockwise so that a controller can start the operation.
3. LAM3 and LAK2D Installation:
Align a bolt on LAK2D controller with a notch on LAM3 to insert downward. There is one 3/16”*15 lock
screw circled in the figure below to fix an actuator and controller.
To Next Page
Loading...
