22
4. LAN5 and LAK4D Installation
4.1 Step 1: Align a bolt on LAK4D controller with a notch on LAN5 to insert downward(Fig. 1). There is a
tube-bolt circled in the fig.2 to fix an actuator and controller.
Fig. 1
Fig. 2
4.2 Installation of LAK4D Fixer: After inserting connectors of an actuator and a key box，vertically insert back
the fixer on LAK4D controller (A) , and then fasten the up fixer and down fixer on LAK4D controller (Fig. 3).
Before inserting the main power cord，rotate out the locker (B) along the arrow direction to insert power cord
(Fig. 3) and then pull it back (Fig. 3) along the arrow direction.
To Next Page
Loading...
