23
4.3 Release of LAK4D Fixer:
4.3.1 One side of the fixer can be released (Fig. 5) by strongly pressing both sides of the fixer on LAK4D
controller (Fig. 4).
4.3.2 Using a screwdriver to prize the bottom of power cord fixer on LAK4D controller (Fig. 6-D).
5. Installation of LAFS Pedal Switch: The pedal switch can directly place on the ground to use. Don’t stamp
on two pedals simultaneously. In addition, there is a powerful magnet attached on the back of pedal switch.
Users can use it to attach on the surface of iron metal for convenient movement.
Don't stamp on two pedals simultaneously.
To Next Page
Loading...
