㧙㧙
٨Warning Function
˴˴If the boost level exceeds the warning value, the unit will warn the user will an audible buzzer and
visually on the display. The boost value will be lowered to the set value. This function protects the
engine and turbocharger from excessive boost.
٨After Image Display Function
˴˴When the boost changes from positive pressure to negative pressure, the maximum boost under
positive pressure can be displayed for 3 seconds. This function can be turned off.
٨Data Memory Function
˴˴Each setting value is saved in the internal memory; the saved values are retrievable even after the
ignition is shut-off or the battery is disconnected.
٨Exhaust Bypass Select Function
˴˴Can be used as swing valve type (internal wastegate/actuator) or poppet valve type (external
wastegate) for a large capacity turbocharger.
٨Boost Unit of Measure Select Function
˴˴The boost unit of measure is selectable between kPa and PSI.
٨Data Lock Function
˴˴The setting data can be protected by a password to prevent unwanted or accidental changes.
٨ This manual indicates items you need to pay attention to in order to install this product safely
and lists precautions to avoid any possible damage and/or accidents.
٨ For any missing, defective and/or damaged parts, contact your Authorized HKS Dealer.
٨This product was developed for racing use. To use this product on public roads, follow the
necessary laws, procedures and regulations for a tuned/modified vehicle.
٨HKS will not be responsible for any damage caused by incorrect installation and/or use or use
after modification and/or dismantling of this product.
٨This product was designed based on installing it onto a factory vehicle or a vehicle using other
HKS products. The performance and/or safety cannot be guaranteed if this product was
installed onto other inapplicable vehicles.
٨This product works only on vehicles with a DC12V negative ground.
٨The specifications of this product are subject to be changed without notice.
٨This manual is subject to be revised without notice.
٨This manual must be given to the end user after installation is complete.
To Next Page
Loading...
Need help?
General
