Hobart A200 - WARNING SYMBOLS; SAFETY INSTRUCTIONS; NEVER ACTIONS

4
Qualified installation personnel. Any ‘work’ performed on the mixer, including
installation, must be by personnel who are experienced and familiar with precautions
required, have complied with all requirements of state and local authorities having
jurisdiction. The installation must comply with national or local requirements of the
country of destination of the appliance.
Qualified Service Personnel: Those who are familiar with Hobart mixers,
competent, trained and approved by Hobart. All service personnel are required to be
equipped with a complete set of manuals and original service parts.
3.3 WARNING SYMBOLS.
The "Warning" symbol is found primarily where the corresponding
warnings are important for the safe use of the machinery.
This symbol is used when there are risks of an electrical nature (Prior to
servicing the machinery, always disconnect the power cable from the
mains supply)
3.4 SAFETY INSTRUCTIONS
A FULLY TRAINED AND COMPETENT PERSON MUST ONLY USE THE
ATTACHMENT AND/OR MIXER.
When manoeuvring or lifting a bowl and contents with a total weight in
excess of 25kg a bowl truck must be used. Avoid manual
handling operations that involve a risk to health as far as
reasonably practicable.
This equipment should only be transported and stored in an environment with an
ambient temperature above 5
O
C and less than 55
O
C.
The following instructions must be observed when using the mixer.
Note: The mixer must only be used for the purpose it was design and inline with the
supplied operating instructions.
When mixing ingredients care must be taken to avoid the inhalation of dust
particles e.g. flour. Reference should be made to product supplier’s data
sheets to ensure adequate precautions and protections are taken.
3.5 NEVER
• Operate the mixer or attachment if a fault develops or the mixer is unsafe.
• Wear loose clothing.
• Attempt to reach into the bowl when mixing.
• Access rotating parts.
• Fit the agitator to the mixer without a bowl in place.
• Leave the agitator on the machine without the bowl being fitted.
• Operate the mixer with both attachment and agitator fitted.
• Leave the gear lever in mid position.
• Use the gear lever to stop the machine.
• Change speed whilst the mixer is operating.
• Use excessive force when operating which could affect the stability of the mixer.
• Operate the mixer if parts are disassembled.