Hobart XVS Series User Manual

OM−221 534 Page 5
3-3. On Button And Low Battery Indicator − XVS Model
1 On Button
Press the On button to check if the
lens is working properly.
When the On button is pressed,
the lens should darken twice and
return to the clear state. Do not use
the helmet if the lens does not
function as described (see
Troubleshooting, Section 8).
 The lens turns off automatic-
ally (clear state − No. 4) 15−20
minutes after the last arc.
Press the On button to re-
sume welding.
2 Low Battery Indicator
The low battery indicator lights
when 2−3 days of battery life re-
mains.
If battery power is low, replace the
two AAA Alkaline batteries (see
Section 6).
1
2
3-4. Lens Delay Control − XVS Model
1
1 Lens Delay Control
The lens delay control is used to
adjust the time for the lens to switch
to the clear state after welding.
The delay is particularly useful in
eliminating bright after-rays pres-
ent in higher amperage applica-
tions where the molten puddle re-
mains bright momentarily after
welding. Lens delay adjusts from
fast to slow.

Hobart XVS Series Specifications

General

Brand	Hobart
Model	XVS Series
Category	Welding Accessories
Language	English