Gas
09-5
The following applies to stop valves and valves:
• All the valves on gas devices must be closed while driving.
• The lower photograph shows the shut off valves when
they are closed. To open the valves, they must be turned to
a vertical position. (See upper photo)
• No ring point may be in operation when lling the petrol
tank of your vehicle on ferries or in the garage.
• Open the door of the gas bottle cabinet.
• Close the main stop valve on the gas cylinder. Pay attenti-
on to the direction of the arrow.
• Unscrew the gas pressure regulator/ high-pressure hose*
by hand from the gas bottle (left-handed thread).
• Loosen the xing strap and remove the gas cylinder.
• Replace the full gas cylinder in the gas bottle cabinet and
carefully fasten it using the xing straps.
• Screw the gas pressure regulator/ high-pressure hose* by
hand on to the gas bottle (left-handed thread).
• Only when equipped with a crash sensor: Press on the
hose rupture protection (green button) on the high-pressure
hose (see 09-7).
• Check that gas is not escaping from the connection point
using leak detector spray.
• Close the gas bottle cabinet door.
Do not smoke or ignite open ames while changing the gas
cylinders. After changing the gas bottles, check whether
there is any gas escaping from the tie-in point by spraying it
with leak detection spray.
Changing gas cylinders
Gas stop valves
Every gas device is tted with a corresponding gas stop
valve.The gas stop valves are located in the kitchen drawer
above the cutlery tray or in the lower kitchen cupboard. They
have been marked with the corresponding symbols.
Heating
(Oven*)
Gas cookerRefrigerator
To Next Page