Chassis
03-3
3.3 Levelling supports
*
The levelling supports are located in the rear area by the
frame extension.
Swinging out the levelling supports
• Place the crank on the hexagon head
j
.
• Turn the crank to move the support to a vertical position.
• If necessary, secure the foot
k
to prevent it from sinking
into the ground and place it on a rm base.
• If the levelling support is in a vertical position, the support
will extend telescopically.
• Use the crank to level the levelling supports until the vehi-
cle stands level.
Retracting levelling supports
• Use crank to release levelling supports.
• Continue to crank smoothly until the levelling support is once
again in its initial horizontal position.
- Do not use the levelling supports as a car jack. Their sole
purpose is to stabilise the motor home when it is parked.
- Always load the levelling supports evenly (max. 500 kg per
support).
- Always retract the levelling supports and secure them before
driving.
- Clean the levelling supports regularly and grease them slightly.
2
1
2
The telescopically adjustable foot may only be extended
as far as the yellow marking!
To Next Page