32
Jib
Take the jib sheet. Thread one
end in the external hole of the jib
traveler car and secure it with a
knot. The knot is outside
the frame.
Lead the jib sheet to one of the clew
blocks and back through the second hole
of the Trentec traveller car, then back
to the jib block on the front crossbar,
leading it first through the sheaves and
then under the strap of the cam cleat.
Repeat the operation on the opposite
side in a reverse manner : feed the jib
sheet under the strap of the opposite
jib block on the front crossbar, then
between the sheaves, then through the
2nd hole of the Trentec traveller car (the
one towards the inside) from outside to
inside, and then back to the first hole
of the traveller from inside to outside.
Secure the end of the line with a knot.
1. Shackle the jib tack to the
4th or 5th hole of the forestay
adjuster (depending on the
sailing conditions).
To Next Page
Loading...
Need help?
General
