Pulley
T Handle: There are two T-handles on the kayak that operate
the up/down control funtion of the rudder. Simply pull on the UP
handle on the right to raise the rudder and the DOWN handle on
the left to lower the rudder. When the rudder is down, pull the line
tight and pull it into the cleat near where the T-handle exits the
hull. This will make sure that it rmly stays down.
Bungee
® Attached
to Cord
6
Up/Down Control Assembly/ Operation
Steering Control Trim
The following detail explains how the up/
down rudder control is set up inside the
kayak.
To achieve a good, responsive feel with
the steering system, you may occasionally
need to adjust the tension of the steering
lines (follow the diagram at right).
Pull more of this line
and wrap it around the
screw to trim your boat
to the left.
Pull more of this line
to trim your boat to
the right.
These two screws hold the end of the
line in place. Turn back the screw a
couple of times to release the end of
the line and tighten the screws back
down to hold the line.
To Next Page
Loading...
Need help?
General
