8
ENGLISH
Use and maintenance manual
Starting
3. Starting
Before powering the machine, carry out the following checks:
1. Check that the balancing machine touches the floor at the three support points.
2. Make sure that all the parts of the balancer are correctly connected and fixed.
3. Make sure that the parameters (voltage and frequency)
of the mains power supply are compatible with
those indicated on the rating plate of the balancer.
4. Make sure the power cable is correctly connected.
5. Make sure the machine shaft and flange hole are clean.
6.
To turn on the wheel balancer press the switch on the side or back of the same; for the models with
touchscreen don’t touch the screen.
To Next Page
Loading...