Black plate (8,1)
Holden WM Caprice Owner Manual (MY12.5) - 2012 - CRC 1st Edition - 6/28
12
7-8 Infotainment System
Adjusting fader and/or balance
Adjust the sound between the front
and rear speakers and the left and
right speakers.
1. Press CONFIG (A).
2. Touch t he Audio tab.
3. Touch Fader/Balance .
4. Fader: Touch ◄ or ► to adjust
the sound between the front and
rear speakers.
5. Balance: Touch ◄ or ► to
adjust the sound balance
between the left and right
speakers.
6. Touch Back to exit.
Setting the equaliser
The vehicle may have an equaliser.
The equaliser enables the user to
control the sound of the audio
system.
With Cu stom selected, you can
adjust the bass/midrange/treble
tone. See “Adjusting the tone”
earlier in this section.
1. Press CONFIG (A).
2. Touch t he Audio tab.
3. Touch Equaliser.
4. Touch the option required.
The option selected is indicated
by
V.
5. Touch Back to exit.
Setting the Speed Dependent
Volume Control (SDVC)
The audio system volume adjusts
depending on the vehicle’s speed.
As the vehicle’s speed increases,
the volume of the audio system also
increases to compensate for the
driving noise.
1. Press CONFIG (A).
2. Touch t he Audio tab.
3. Touch Speed dependent
volume control.
4. Touch the option required.
1: Small volume increase
2: Larger volume increase
The option selected is indicated
by
V.
5. Touch Back to exit.
Setting the Dynamic Distortion
Limiter (DDL)
The vehicle may have a DDL.
DDL limits the amount of amplifier
distortion.
When the limit is reached the
volume will not be able to be
increased.
1. Press CONFIG (A).
2. Touch t he Audio tab.
3. Touch Dynamic distortion
limiter.
To Next Page
Loading...
Need help?
General
